DIP FeaIn smt mounter feeder systems, ensuring component integrity is a key factor in improving placement reliability and efficiency. If the components in the feeder are twisted, reversed, vacant and in the wrong feeder position, it will make it difficult to pick up the material, or even if it is picked up, it will be difficult to identify. If the components with the above defects are pasted onto the board, it will lead to rework. Therefore, smt SMD proofing manufacturers need to ensure that the feeder work in good condition, regular maintenance is essential.
1.Maintenance items of feeder
(1) check whether the contact pin is damaged, to ensure that the pin is free to move in and out.
2)Check the grounding pin, the grounding pin is longer than other pins.
3) Clean the window and cover the strip edge to remove any adhesions.
4) Clean the belt cover wheel to remove any adhesions.
5) Emptying the bin of loose tape.
6) cleaning the inside of the belt bin to remove any adhesives and debris.
7) Cleaning the support end of the belt wheel to remove any labels, adhesives and debris.
8) Double track feeder: emptying the bin of loose material
9) Visually inspect for missing, worn or damaged parts.
10) checking for loose hardware.
11) Inspection for loose parts around the material belt window and gear teeth.
(12) Carrier Tape Drive Motor to check for proper operation of the tape drive motor.
(13) Cover Tape Drive Motor to check for proper operation of the cover drive motor.
(14) Check whether the gear tooth sensor is operating normally.
(15) Peel Arm Sensor to check if the peel arm sensor is operating normally.
(16) Check the PSV sensor for proper operation.
17) 8mm and 12,mm feeders - check feeder calibration.
18) Double Rail Gold Feeder - make sure all leader decks are on the feeder. eeder
Feeder system of smt mounter
2022 12/14